Reef Central Online Community

Home Forum Here you can view your subscribed threads, work with private messages and edit your profile and preferences View New Posts View Today's Posts

Find other members Frequently Asked Questions Search Reefkeeping ...an online magazine for marine aquarists Support our sponsors and mention Reef Central

Go Back   Reef Central Online Community > Blogs > Floyd R Turbo
Register Blogs FAQ Calendar Mark Forums Read

Notices

Uncategorized Entries with no category
Old

Algae Scrubber Basics 4 of 14

Posted 02/19/2012 at 08:31 AM by Floyd R Turbo

Spray Protection

As far as spray and salt creep is concerned, you want to avoid buildup on the lamp itself. No matter what you do, there will still likely be some buildup due to evaporation, so you will want to wipe off the lamp or fixture periodically (as needed). Make sure the lamp has cooled down, remove the lamp if possible, and wipe it down with a soft cloth and warm water. This is rather easy to do in place with T5HO lamps, and more difficult for spiral and multi-tube CFLs;...
Floyd R Turbo's Avatar
Either busy or sleeping
Posted in Uncategorized
Views 3403 Comments 0 Floyd R Turbo is offline Edit Tags
Old

Algae Scrubber Basics 3 of 14

Posted 02/19/2012 at 08:30 AM by Floyd R Turbo

Fasteners

Most people have uses standard zip-ties to secure the screen to the slot pipe, since they are cheap and easy to use. Generally you have to use new ones each time you clean the screen (because you have to cut them), or you can re-use them if you’re handy with the tip of a razor blade and can get them to release.

You can also use releasable zip ties (I found them in the electrical section of Home Depot), but they’re not as easy to release as you would think...
Floyd R Turbo's Avatar
Either busy or sleeping
Posted in Uncategorized
Views 3345 Comments 0 Floyd R Turbo is offline Edit Tags
Old

Algae Scrubber Basics 2 of 14

Posted 02/19/2012 at 08:29 AM by Floyd R Turbo

Cutting the Slot

The width of the slot should be approximately 1/8" wide, the same length as the screen which you are using (as exact as possible), and as straight as possible. Cutting a straight, even width slot is arguably the most difficult and critical part of building an Algae Scrubber. If the slot is crooked or uneven, the screen may not hang properly, and there may be areas where the flow is lighter and heavier. This can result in sections of weak growth.
...
Floyd R Turbo's Avatar
Either busy or sleeping
Posted in Uncategorized
Views 5023 Comments 0 Floyd R Turbo is offline Edit Tags

All times are GMT -6. The time now is 12:18 PM.


TapaTalk Enabled

Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2020, Jelsoft Enterprises Ltd.
Powered by Searchlight © 2020 Axivo Inc.
Use of this web site is subject to the terms and conditions described in the user agreement.
Reef CentralTM Reef Central, LLC. Copyright ©1999-2014
User Alert System provided by Advanced User Tagging v3.3.0 (Pro) - vBulletin Mods & Addons Copyright © 2020 DragonByte Technologies Ltd.