Tunze 6255 broken wires?
I have a 6255 that is basically new (1.5 months of use) that is intermittently stopping. I think I traced it back to the position of the wires as they enter the pump, as when I move them around the pump starts and stops. The power supply works fine on a different controller so I don't think that is the problem. Is it possible that the wires broke internally or disconnected, or could it be a different problem.
Thanks in advance PS this is the same pump that I was recommended to use a 6105 prop on, but I had decided to stick with the original prop, so that is not the problem |
It is possible but would be unusual, can I get a photo of the cable where it meets the motor? Pumps made in the last year have a pretty robust cable with a strain relief bushing, and I would be very surprised if one has a cable issue.
|
here are some photos- it looks fine but it was cutting out when I wiggled the cable
https://i.imgur.com/F7TETGAl.jpg https://i.imgur.com/lZx4LlVl.jpg https://i.imgur.com/1pDXukBl.jpg https://i.imgur.com/J8wQMyrl.jpg |
Can you email me a copy of the receipt? It is a newer pump, there are 5 small wires in the cable but such an issue is really rare.
|
Taken care of! Great customer support from Roger as always!
|
Sincerely, thank you!
|
All times are GMT -6. The time now is 09:29 AM. |
Powered by vBulletin® Version 3.8.4
Copyright ©2000 - 2024, Jelsoft Enterprises Ltd.
User Alert System provided by
Advanced User Tagging v3.3.0 (Pro) -
vBulletin Mods & Addons Copyright © 2024 DragonByte Technologies Ltd.