View Single Post
Old 04/09/2003, 11:49 PM   #30
Zephrant
Premium Member
 
Zephrant's Avatar
 
Join Date: Mar 2002
Location: Spokane, WA
Posts: 3,237
Chris- I knew I had read about that trick here someplace, thanks!

Neat idea on the Al foil- I bet the sheet doesn't roll on it like it does the pins. Maybe I'll take some solid core #22 wire or so, and hammer it flat a little. hmmm....

When I do inside baffles, I put them in after all four sides are done, but before I put on the top and bottom. That way I can trail fit them. I have started using Weldon #3 to put them it. I still space them up a touch with a pin at each end, wick it in, and drop it. It still makes a clearer joint then what I get when I just wick it in from the sides. It seams like I always get bubbles that way.

Zeph


Zephrant is offline   Reply With Quote