View Single Post
Old 04/13/2003, 09:58 PM   #32
C_Kritter
Registered Member
 
C_Kritter's Avatar
 
Join Date: Feb 2003
Location: Duarte, CA
Posts: 162
ok, i messed up in joining my front, back and side panels. when i dry fit the flange to the rectangular reactor, i noticed a gap about 1/32 of an inch. it is an area where i can no longer scrape. can i continue using Weld-On #4 to join the flange or should i use Weld-On #16 instead? Or, should i use #4 to adhere the flange to the body then bead on #16 to create a seal? thanks for any input.

ramon


C_Kritter is offline   Reply With Quote