View Single Post
Old 02/27/2004, 09:33 PM   #99
Registered Member
skripo's Avatar
Join Date: Dec 2003
Location: Montreal
Posts: 83
I must have been dreaming, here it goes again:

I have been trying to make an O-Ring but the seal always comes out worse than 2 flat surfaces with an O-ring between. How do you recommend I do this in 1/4 acrylic and what tools do I need.

I am also looking to make the seal flangeless, just a quarter turn should unlock it. Any ideas?


skripo is offline   Reply With Quote