View Single Post
Old 05/15/2004, 11:35 AM   #115
Registered Member
Join Date: Jun 2003
Posts: 4,228
Originally posted by bulkhead
Assembly question, I read that most folks join the ends to the front and then all three to the back and then the box to the bottom. I'm curious if there is ever a problem lining up the bottom of the end pieces to the bottom of the front and back. It seems they would have to be perfectly aligned to get a good, flat, edge to join to the bottom room for error....Am I retarted and missing something or just over analyzing a simple procedure
This will depend entirely on how you machine your pieces, if you use a jointer - this can be a real problem hence my aversion to these machines for tanks. I use a router table with a fence so you push the pieces between the fence and the router ensuring identical width (+/-.002" or so)


Acrylics is offline   Reply With Quote