Thread: renew
View Single Post
Old 04/02/2018, 07:01 PM   #3
Dr. Reef at ur service
bnumair's Avatar
Join Date: May 2009
Location: Tulsa, Ok, USA
Posts: 7,796
Blog Entries: 15
on the replacement bin side there are 3 leds.
1. Bin level
2. High
3. Low

1. will blink if your reservoir of freshly made saltwater is near empty (at level where your sensor is)
2. will blink if high sensor inside the metering well doesnt release. usual slight to medium tapping on the well can free the float.
3. will blink when low sensor in the well does release. tapping on the well can free the float.
2 and 3 are usually caused by debris in the water making the float valve stick.

if you have the mode selected as day then renew will divide the 50 gal over 24 hrs and not doing all 50 gal at once.
only on continuous mode it will do all 50 gal at once.

Water Quality: NO3 0,Phos 0,Cal 440,Alk 7.5,Mag 1300

"Reef Fast, You Crash, Reef Slow, You Pass" Mike's Reef 3:16

Current Tank Info: 350g DT,95g sump, 50g Frag tank, 4800gph return 4x Sea swirls. 6x AI Vega Color. 200# Pukani rock, dual recirculating skimmer, Biopellet, GFO Carbon rx's, Cal rx. Closed loop. 1.5hp chiller, genesis renew. Apex & RKE
bnumair is offline   Reply With Quote