Reef Central Online Community - View Single Post

mattr777 · 07/21/2019, 04:09 PM

I just added a slave to my stand-alone doser and I am having this same issue. I am able to assign the slave and I see the PAB and Slave Device showing under the Master but when I click and highlight the slave and hit configuration it says The PAB-Device not responding! If I dose pump 1 both the master and slave pump 1 runs but I need to configure the slave to be pump 5-9.

07/21/2019, 04:09 PM	#21
mattr777 Registered Member Join Date: May 2012 Location: Deerfield Beach, Fl Posts: 208	Any solution? I just added a slave to my stand-alone doser and I am having this same issue. I am able to assign the slave and I see the PAB and Slave Device showing under the Master but when I click and highlight the slave and hit configuration it says The PAB-Device not responding! If I dose pump 1 both the master and slave pump 1 runs but I need to configure the slave to be pump 5-9.