[DougSupreme]

Originally Posted by BigDave

I use the OM wavemaker too.

My inlet pulls from the lower middle of the tank.

My 4 outlets are at the top... one in each corner and then two in the middle like below:

1 2 3 4
| | | |
\ / \ /

I use 45º outputs so that the outlets point down and across the tank. 2 in one direction, 2 in the other. This gives me a good rolling current one direction that then switches to a rolling current in the other.

This is on a smaller 120 gallon Cube.

My inlets are going to be in back wall of the tank.

I'm not sure how you are describing your outlets.

_______________
|1 2|
| |
|3 4|
| |
| |
|______________|

This looks like crap. Not sure if you can figure out what
I meant.

I think, after rereading I know what you mean. There are 4 outlets across the back wall of your tank alternating facing left and right (at 45degrees)
Like that?

Or do you have an outlet in each corner?