View Single Post
Unread 09/22/2017, 11:58 PM   #14
cpllongjk
Registered Member
 
Join Date: Sep 2005
Location: Modesto, Ca
Posts: 1,066
Im just curious did you assign your slave pump to have pumps 5-8?

I had the same issue when adding a 2nd doser to my GHL Profilux. In the GCC settings, when adding the slave doser you would think that the master doser would be pumps 1-4 and the slave would auto add 5-8 but what happened was the master and slave pump both had 1-4 assigned.

What was happening was none of the pumps would dose because there was conflict.

Try this:

Open GCC
Look for the GHL Doser Slave somewhere (should be in the systems section)
You might have to click the drop down button to see the dosers.
One doser should be marked master and the other marked slave.
Highlight the slave doser and click configuration.
A dialog window should pop up and all you need to do is make sure the pumps are labeled 5, 6, 7, and 8.
Once you make this change make sure you click SAVE at the top of GCC.

Anyways this is how I got mine to work so I hope it works for you too.

Let me know!


cpllongjk is offline   Reply With Quote