View Single Post
Old 08/03/2020, 05:56 AM   #2
Member No. 1
Ver. 2.1
Member No. 1's Avatar
Join Date: Mar 2005
Location: Rehoboth, MA
Posts: 1,704
Originally Posted by tmccaffery View Post
I bought a used Profilux 4 and trying to remove everything and have factory default. It has in system extra powerbars; vortech controller etc and I dont have that. Is there away to clean everything out?
If you haven't already, download and install GHL's GHL Control Center (GCC)
This only runs on a PC, so if you have a MAC, you will need to run Boot Camp, Parallels, etc.
Connect your P4 via the USB cable. Under the system tab, you can delete the modules you don't have. I would suggest deleting them all.
Then up top, open the Devices tab, there you can reset defaults, and update the firmware.

"I never make mistakes...
I thought I did once, but I was wrong"

Current Tank Info: In the process -
Member No. 1 is offline   Reply With Quote