So I didnt like the first finish on the trim...
So off it came, sanded, and I repainted and used Min-Wax Poly Spray for the finish...
I added an extra layer of the laminate as a little extra insurance...
The only way I was moving the stand by myself:
And the stand in its new location:
So even though there are no baffles in it yet, I decided to test fit the sump - a 75 gallon Aqueon (which I think used to be All-Glass), plus I wanted to make some room in the garage
Test fitting the skimmer and trying out two new-to-me Tunze 6100's:
Started to cycle some rock I had lying around though I probably wont use much if any of it:
Well thats about it for now...
Next steps:
1- Drill the display after getting hole saws.
2- Pick up glass for overflow and install.
3- Move display into place and install plumbing. I will leak test from inside!
Question for the experts:
In lieu of installing an overflow, would a single herbie syphon stand-pipe drain be very detrimental as far as surface skimming goes. Plan to push maybe 800-1200 gph through the return, and have 3 tunze and 1 vortech for flow. I want to keep the display as clean as possible...