View Single Post
Old 03/20/2017, 07:05 PM   #1
Radar1721
Registered Member
 
Join Date: May 2016
Posts: 46
Optical level sensor question

I'm designing my ato system and I want to design a solution that will keep my ato container refilled directly from my ro/di system. In order to avoid the many small top offs each day and the TDS creep, I want to set a low level and high level in my ato container so once the bottom level sensor is tripped, an SV-1 solenoid will open and allow the ro/di to fill up the ATO container until it reaches the top level.

Can I program that on the Apex? I think the logic should work fine as the water level drops, but can it handle filling up past the first sensor to the second one without shutting off once it passes the bottom sensor? Is this the wrong way to go about solving this?


Radar1721 is offline   Reply With Quote