View Single Post
Unread 06/13/2016, 07:40 PM   #14
SPotter
Registered Member
 
SPotter's Avatar
 
Join Date: Jun 2010
Location: Mt. Pleasant, SC
Posts: 5,691
Update....

I got the mesh attachment last Thursday and immediately made the changes on the reactor by removing the ball and putting in the mesh. I already had 500ml of phosguard in the reactor and it was pretty easy to make the change without removing the media. I hooked everything back up but still wasnt getting any tumble. After a few emails back and forth we determined that the pump was too small to make the media tumble but Dan suggested that I continue with it and see what happens. My po4 was .06 when I started it on Thursday. By saturday it had dropped to .03 and now today its down to .00 ppm. It has taken a little time for me to get used to the reactor but now that I have running properly I think its a great reactor and the customer service has been top notch! Thank you Dan for all of your help.


__________________
Steve

Am I really doing all of this for a fish tank??????

Current Tank Info: 360g Envision Acrylic Tank, Closed Loops, Vectra L1's, MP40QD's, 400w Radiums, Regal 300ext, Dastaco Ext3 CaRx, Controlled by GHL Profilux
SPotter is offline   Reply With Quote