View Single Post
Old 05/02/2019, 08:12 AM   #31
smatter
Registered Member
 
smatter's Avatar
 
Join Date: Dec 2002
Location: Madison, WI
Posts: 2,125
Quote:
Originally Posted by SpectraPure View Post
Typically you would put the sediment and carbon in first. Run about a gallon out of that with blank DI. Then add the Maxcap cartridge. Run it until the TDS on the right meter set to in is 0, then add the Silicabuster. Run it until the right meter set to out is 0. Then you are good to go.

=) Jeremy
Is it required to run an empty, if that's what you mean by blank, DI cartridge in the DI canister when running my CSPDI unit? It seems to work fine without it. I quit running DI because I was blowing through it way too fast. I suspect it is a CO2 problem. My tank doesn't seem to mind the 2ppm of TDS that gets past the membrane.


smatter is offline   Reply With Quote