View Single Post
Old 08/03/2014, 12:42 PM   #305
karimwassef
Registered Member
 
karimwassef's Avatar
 
Join Date: May 2004
Location: Dallas, TX
Posts: 10,903
One more little DIY in there. I had an old premade skimmer that used bio balls for all injection. It was about 18" or 24" tall. I removed the top from the base and cut off the bioball pipes. I converted them into my outlet.

I put my skimmer (inlet, injectors, etc) in the middle with the old skimmer base underneath and the old skimmer body and top above.

Then I used the old outlet in the base to feed the re injection pump.

I can actually turn the air injection & re circulation off and the skimmer stays white with bubbles for minutes.


karimwassef is offline   Reply With Quote