View Single Post
Unread 12/04/2017, 09:27 PM   #4
Lsufan
Registered Member
 
Join Date: Nov 2013
Location: Baton Rouge
Posts: 1,410
I would just use shims. It may be easier to remove the tank from the stand & level the stand itself. Get it close that way then place the tank back & adjust it the last little bit to get it completely level. I would figure out what corner is the highest & what corner is the lowest. Then get the low corner up to where it is level with the high corner & then come back & do what needs to be done to the other two corners. Basically u want to shim the 4 corners of the stand to get it level, then u can come back & add shims inbetween the corners if needed. If u don’t have any center supports on the stand then u may be fine by just shimming the corners.



Last edited by Lsufan; 12/04/2017 at 09:53 PM.
Lsufan is offline   Reply With Quote