View Single Post
Unread 11/19/2005, 03:25 AM   #76
goby1
Premium Member
 
Join Date: Feb 2004
Location: san francisco
Posts: 364
Zephrant, I found this thread by searching for your name after reading the acrylicman thread. I still have a question regarding flush trimming. Will it suffice to use a bit with the bearing on it? How is the tolerance on these bits.... i.e. will they remove any of the acrylic that the bearing is gauging off of? Would I set the depth of the bit so that the bearing is JUST below the edge to be flush trimmed? Is a router table (using a straight bit with no bearing) vastly superior? Basically, will freehand with a bearing-style bit suffice? Thanks so much.... G1


goby1 is offline   Reply With Quote