View Single Post
Unread 10/15/2020, 01:07 PM   #6
wtac
Registered Member
 
Join Date: Sep 2004
Location: Toronto and Calgary, Canada
Posts: 377
The bond in that seams, IMHO, is at most 20%. One should not see any bubbles or "white" areas in the seam.

Looks like there is a solvent weld at the perimeter of the seam and will be difficult if not impossible to get the WO to wick through the entire thickness of the panel.

You will most likely have to cut it apart and get clean edges to do a proper solvent weld.

JM2C


wtac is offline   Reply With Quote