View Single Post
Old 07/21/2019, 05:09 PM   #21
mattr777
Registered Member
 
Join Date: May 2012
Location: Deerfield Beach, Fl
Posts: 208
Any solution?

I just added a slave to my stand-alone doser and I am having this same issue. I am able to assign the slave and I see the PAB and Slave Device showing under the Master but when I click and highlight the slave and hit configuration it says The PAB-Device not responding! If I dose pump 1 both the master and slave pump 1 runs but I need to configure the slave to be pump 5-9.


mattr777 is offline   Reply With Quote