12/30/2020, 12:50 PM
|
#5132
|
Registered Member
Join Date: Aug 2010
Posts: 12
|
Quote:
Originally Posted by shellydsilva
Hi,
I am using capillary method to glue the 5mm acrylic pieces. But I end up like this joint. When the glue is applied, I can see that the glue is covering the entire width of the acrylic sheet. But once the glue dries, I get the edge finish like this.
What could be the reason? I trim the edge using a flush trim router bit after the piece is cut using laser. Using Weldon glue.
|
|
|
|