|
08/18/2006, 10:27 AM | #1 |
Premium Member
Join Date: Jun 2004
Location: West Hempstead, NY
Posts: 2,124
|
Drilling and waterproofing holes in plywood tanks
The tank box is put together 90X62X70X61 X32H. It will have an external horizontal overflow across the back (70"). I am planning to drill for 3 2" bulkheads in the overflow and two holes through the back of the tank for my closed loop manifold. (I don't know what size these holes should be so suggestions are welcomed.)
The tank will be fiberglassed and then epoxy paint will be applied. -Do I do the fiberglass and epoxy first and then drill? -How do I seal the holes, with just epoxy? -Do I need to drill the hole slightly larger to account for the epoxy layers, meaning if I drill the hole the size I need will adding the epoxy make them smaller? Thanks.
__________________
Leah Amanda Current Tank Info: First salt tank 1985, current tank 150 g acrylic |
08/18/2006, 11:59 AM | #2 |
Registered Member
Join Date: Aug 2003
Location: NH
Posts: 265
|
I don't know too much about plywood tanks, but I have built a few boats using plywood and epoxy. The way I've sealed up holes is to make the hole about 1/4" larger than necessary and then fill it with thickened epoxy - as if you were trying to patch the hole. Once the epoxy cures you then drill the correct sized hole in the epoxy. What you're left with is a 1/4" ring of epoxy around the edge of the hole. Since the epoxy is bonded to the plywood edge it creates a totally waterproof opening.
Probably overkill since the bulkhead should make a water tight seal, but something to consider. |
08/18/2006, 11:12 PM | #3 |
Registered Member
Join Date: Jun 2005
Location: Corona Ca.
Posts: 674
|
The bulkhead should do most of the sealing. I would glass the tank, then drill for the bulkheads. Make sure the sealing surface is flat wher the gasket goes. If necessary, create a little clearance with a drum sander. Give the inside of the hole a couple of coats of resin. Install bulkheads.
|
08/18/2006, 11:35 PM | #4 |
Premium Member
Join Date: Jun 2004
Location: West Hempstead, NY
Posts: 2,124
|
Thanks guys.
__________________
Leah Amanda Current Tank Info: First salt tank 1985, current tank 150 g acrylic |
08/19/2006, 08:21 AM | #5 |
Moved On
Join Date: Apr 2002
Location: In America's Dangling Junk State.
Posts: 6,413
|
after you cut the hole, the cut area should be resined over. any water/humidity that gets into the cut will swell the wood otherwise, which can make the bulkhead useless.
|
|
|