|
07/18/2018, 04:29 PM | #1 |
Registered Member
Join Date: Oct 2004
Location: WI
Posts: 3,014
|
Tunze 6105 issues...need help!
tom obrecht's Avatar
Join Date: Oct 2004 Location: WI Posts: 2,944 6105 problem -------------------------------------------------------------------------------- I currently run 4 6105's on my display and have had issues with locking up impellers. They operate normally until they just stop as if they are calcified so I remove the stopped PH, soak in vinegar overnight, reassemble and nothing! I have tried a different motorblock assembly and still nothing. I resoak, clean again...still no luck. This has happened 2 times now! Now I'm down 2 powerheads! They are the newer models (with attached controller) so they are not ancient. Is this an impeller issue, user error or something else? Any help would be appreciated!
__________________
Reef keeping is where Murphy's Law and your bank account collide!! TOTM May 2006 |
07/18/2018, 05:11 PM | #2 |
Registered Member
Join Date: Feb 2003
Location: Fairfield, CT
Posts: 1,516
|
Have you reached out to Roger Vitko?
__________________
- Leon (aka - Water Dog) Deep Blue 57 Edge ATI Acro Garden Build Thread http://www.reefcentral.com/forums/showthread.php?p=25573384#post25573384 Current Tank Info: DeepBlue 57 Edge |
07/18/2018, 05:26 PM | #3 |
Registered Member
Join Date: Oct 2004
Location: WI
Posts: 3,014
|
I will tomorrow. I did post in Tunze forum tho
__________________
Reef keeping is where Murphy's Law and your bank account collide!! TOTM May 2006 |
07/19/2018, 08:47 AM | #4 |
Proud user of IO Salt!
Join Date: Jun 2006
Location: Torrance, CA
Posts: 9,136
|
Have you tried switching power supplies?
__________________
Mike <*)))>{ <*)))>{ <*)))>{ <*)))>{ ReefKeeping.com TOTM Nov 2012 Socalireefs Featured Reef Oct 2011 Current Tank Info: 60*30*20, 8x54 ATI Powermodule, ReefBrite XHO, ATB Elegance 200, Aquamaxx CTech CaRx, Ecotech Vortechs, Apex Controls, WM Ecobak powered. RedSea Reefer 170, MP10, Apex Jr, Ecotech Radion XR15, Aquamaxx WS-1 |
07/19/2018, 09:31 AM | #5 |
Registered Member
Join Date: Oct 2004
Location: WI
Posts: 3,014
|
__________________
Reef keeping is where Murphy's Law and your bank account collide!! TOTM May 2006 |
07/20/2018, 07:18 AM | #6 |
Registered Member
Join Date: Oct 2004
Location: WI
Posts: 3,014
|
Thanks to Roger I figured it out. The impeller had calcified to the shaft. When I pulled the impeller out to clean the shaft came out as well. I thought it was one assembly until talking to Roger. Removed the shaft from the impeller, soaked and cleaned and reassembled. Just like new!
__________________
Reef keeping is where Murphy's Law and your bank account collide!! TOTM May 2006 |
07/20/2018, 08:38 AM | #7 |
Registered Member
Join Date: Feb 2003
Location: Fairfield, CT
Posts: 1,516
|
Nice... Roger’s service and attention to detail is top notch!
__________________
- Leon (aka - Water Dog) Deep Blue 57 Edge ATI Acro Garden Build Thread http://www.reefcentral.com/forums/showthread.php?p=25573384#post25573384 Current Tank Info: DeepBlue 57 Edge |
07/20/2018, 09:02 AM | #8 |
Registered Member
Join Date: Oct 2004
Location: WI
Posts: 3,014
|
One more reason I use Tunze products!
__________________
Reef keeping is where Murphy's Law and your bank account collide!! TOTM May 2006 |
07/20/2018, 11:13 AM | #9 |
Registered Member
Join Date: May 2008
Location: Columbus Ohio
Posts: 6,361
|
|
|
|