|
02/22/2017, 06:36 PM | #1 |
Registered Member
Join Date: Jul 2010
Posts: 70
|
MP40w blinking red
The power supply to my MP40w got wet and stopped working. My wet side was in bad shape as well so I ordered a new wet side along with a new power supply. Now my issue is that the driver only blinks red. I tried holding down the mode button until it flashes white and following the rest of the steps to get it working again but it won't stop blinking red. I tried unplugging and plugging in again with no results. I'm at a loss here. The driver never got wet just the power supply and had been working flawlessly before. Any help would be appreciated.
|
02/23/2017, 12:01 PM | #2 |
Registered Member
Join Date: Mar 2013
Location: Allentown, PA
Posts: 1,956
|
Dave,
It sounds as though you may have purchased or been sent the incorrect power supply. I would recommend comparing the new power supply with your damaged one to see if you received the same model.
__________________
Alex Y. Customer Service Representative at EcoTech Marine Call: 1-800-785-0338 Ext. 2 or E-mail: Service@EcoTechMarine.com |
02/23/2017, 04:16 PM | #3 |
Registered Member
Join Date: Jul 2010
Posts: 70
|
I think your right. Just checked and I have a 36v power supply instead of a 24v. Thank you. Now I get to go through the whole return process.
Would there be any chance that I may have damaged my driver or pump motor by plugging the 36v power supply to them? |
|
|