|
06/18/2018, 06:07 AM | #1 |
Registered Member
Join Date: Oct 2005
Location: hightstown, NJ
Posts: 262
|
Heater in biocube 16 LED without removing the false floor
Is there an adequate heater in that fits in the first chamber of the biocube 16 LED without removing the false floor? I would like one that is strong enough to keep the tank warm without burning itself out, but that fits in the chamber
thank you
__________________
16gal Biocube LED - New setup Current Tank Info: 14gal nano |
06/19/2018, 11:42 AM | #2 |
Registered Member
Join Date: Oct 2005
Location: hightstown, NJ
Posts: 262
|
i did quite a bit of searching and according to this site, this should fit no problem (75w).
https://www.chewy.com/cobalt-aquatic...herm/dp/138718 i emailed the manufacturer and they confirmed the dimensions of this site. i measured the filter pad and it is 8 inches long, not counting the handle, so this should just fit. i ordered it and it should arrive tomorrow, so i will post the results
__________________
16gal Biocube LED - New setup Current Tank Info: 14gal nano |
06/20/2018, 02:38 PM | #3 |
Registered Member
Join Date: Oct 2005
Location: hightstown, NJ
Posts: 262
|
this heater does in fact fit in the back with room to spare. i did not need to do any cutting either.
it is very expensive, but i like that i did not need to cut or modify the tank in anyway
__________________
16gal Biocube LED - New setup Current Tank Info: 14gal nano |
Thread Tools | |
|
|