|
08/24/2019, 09:22 PM | #1 |
Registered Member
Join Date: Jul 2019
Location: Chicago
Posts: 26
|
Vectra M2 Calibration Issues
Just set up a new tank and using a Vectra M2 pump. Tried to calibrate it via the controller and moved through each step exactly as described. After power-cycling the controller I couldn’t control the speed in Return Pump Mode. No matter what I did the pump would only operate a lowest speed.
Noticed the “W” wasn’t blinking so I thought controller somehow switched to closed loop mode. So I switched controller back to Return Pump mode. Wasn’t sure how to exit so I figured best to power cycle by unplugging cable. Still couldn’t control speed and W not blinking Ended up doing a hard reset so I can now run in return pump mode and control speed, but I know I’m not calibrated. So I can’t use fees mode or speed lock Would appreciate any help! |
08/26/2019, 12:06 PM | #2 |
Registered Member
Join Date: Jul 2019
Location: Chicago
Posts: 26
|
So after another reboot and watching the calibration video so many times that I had to turn off the background music, I finally got this pump calibrated! Took around an hour. Ugh.
|
|
|