|
09/20/2020, 04:38 PM | #1 |
Registered Member
Join Date: Feb 2008
Location: Texas
Posts: 61
|
Light blinking Too Low
Controller is blinking Too Low. I’ve unplugged and plugged the power back in and still the same issue. The controller will pump for about 10 seconds then stop.
Sent from my iPad using Tapatalk |
09/21/2020, 08:18 AM | #2 |
RC Sponsor
Join Date: Apr 2000
Location: Austin Texas USA
Posts: 35,785
|
If only the too low light is on, this means it was erased, the 10 minute timer is zero minutes so right after the start up cycle it goes to too low. We can typically repair this, it will need to be reprogrammed. The most common cause is a power surge or repeated harsh and rapid switching on and off, but water damage and age (usually more than 8 years) can be causes that may not be repairable.
__________________
Roger Vitko Tunze USA "He's for every one of us, stands for every one of us, he'll save every man, woman and child in a mighty Flash!" Current Tank Info: 210 gallon planted tank with Altum Angelfish |
09/21/2020, 10:01 AM | #3 |
Registered Member
Join Date: Feb 2008
Location: Texas
Posts: 61
|
Thanks Roger. Let me know where I should send it. I'm hoping it's nothing serious. I don't see signs of water damage. Thanks.
|
09/21/2020, 12:04 PM | #4 |
RC Sponsor
Join Date: Apr 2000
Location: Austin Texas USA
Posts: 35,785
|
Tunze USA
305 Victor St Austin, TX 78753
__________________
Roger Vitko Tunze USA "He's for every one of us, stands for every one of us, he'll save every man, woman and child in a mighty Flash!" Current Tank Info: 210 gallon planted tank with Altum Angelfish |
09/24/2020, 09:08 AM | #5 |
Registered Member
Join Date: Feb 2008
Location: Texas
Posts: 61
|
Thank you sir! I just mailed it.
|
Thread Tools | |
|
|