How to remove modules, etc?

tmccaffery · 08/02/2020, 07:31 PM

I bought a used Profilux 4 and trying to remove everything and have factory default. It has in system extra powerbars; vortech controller etc and I dont have that. Is there away to clean everything out?

Member No. 1 · 08/03/2020, 05:56 AM

Quote:

Originally Posted by tmccaffery

I bought a used Profilux 4 and trying to remove everything and have factory default. It has in system extra powerbars; vortech controller etc and I dont have that. Is there away to clean everything out?

If you haven't already, download https://www.aquariumcomputer.com/sof...ontrol-center/ and install GHL's GHL Control Center (GCC)
This only runs on a PC, so if you have a MAC, you will need to run Boot Camp, Parallels, etc.
Connect your P4 via the USB cable. Under the system tab, you can delete the modules you don't have. I would suggest deleting them all.
Then up top, open the Devices tab, there you can reset defaults, and update the firmware.

Hellsangelbx · 08/25/2020, 08:23 PM

Did you figure it out and does everything work?

tmccaffery · 08/28/2020, 09:06 AM

Yes figured it out. However, my conductivity probe cant get calibrated. I dont think its a big deal but maybe I need new probe.

08/02/2020, 07:31 PM	#1
tmccaffery Registered Member Join Date: Apr 2011 Posts: 149	How to remove modules, etc? I bought a used Profilux 4 and trying to remove everything and have factory default. It has in system extra powerbars; vortech controller etc and I dont have that. Is there away to clean everything out?

08/25/2020, 08:23 PM	#3
Hellsangelbx Registered Member Join Date: Sep 2014 Posts: 52	Did you figure it out and does everything work?

08/28/2020, 09:06 AM	#4
tmccaffery Registered Member Join Date: Apr 2011 Posts: 149	Yes figured it out. However, my conductivity probe cant get calibrated. I dont think its a big deal but maybe I need new probe.