|
09/21/2018, 05:31 PM | #1 |
Registered Member
Join Date: Dec 2006
Location: New Jersey
Posts: 63
|
Any ideas how to wire this thing?
My dad bought a lifeguard seahorse pump for his pond from Foster and Smith. I'm trying to figure out how to wire it for him.
I attached 2 photos, 1 is the pump itself, the other is the back where the wires get hooked up. Any ideas? |
09/21/2018, 05:43 PM | #2 |
Registered Member
Join Date: Sep 2003
Location: North Carolina
Posts: 20,050
|
Typically there is a wiring diagram on the motor specifying which is L&N you also need to ensure its properly bonded and grounded per the manual..
Take a pic of the motor nameplate/label please
__________________
Who me? Last edited by mcgyvr; 09/21/2018 at 06:06 PM. |
09/21/2018, 08:43 PM | #3 |
Electrician
Join Date: Nov 2006
Location: Canada
Posts: 1,653
|
It's the two studs on the right side there, one will be the hot and the other the neutral.
|
09/22/2018, 07:13 AM | #4 | |
Registered Member
Join Date: Sep 2003
Location: North Carolina
Posts: 20,050
|
Quote:
I thought they may need more guiding but the manual covers the specifics about wire size stipulations,etc...
__________________
Who me? |
|
09/22/2018, 07:17 AM | #5 |
Registered Member
Join Date: Dec 2006
Location: New Jersey
Posts: 63
|
Thanks guys, its not clear though as to which is which. Mcgyvr, i'll try to get a pic of nameplate today. The pump is at my dads house, i'll have to run over there. Thanks for the help
|
09/22/2018, 07:38 PM | #6 |
Electrician
Join Date: Nov 2006
Location: Canada
Posts: 1,653
|
|
|
|