|
12/17/2017, 11:23 AM | #26 |
Registered Member
Join Date: Mar 2004
Location: Alabama
Posts: 2,912
|
Your parameters look good, but for SPS you really need a peristaltic doser or Ca reactor(I prefer the reactor). It's expensive up-front but worth it in the end. You're parameters can slowly shift w/ a doser or reactor but they can be very, very slowly brought back to normal.
I would cut your WC volume in half too. And corals have to eat too, i know--it's a fine balancing act between nutrients and nuisances.
__________________
OK, but where does the meat go! ------------------------------------------------ 120g SPS, 125g mix, 56g FOWLR, 20g qt |
12/19/2017, 08:02 PM | #27 |
Registered Member
Join Date: Apr 2016
Posts: 62
|
I run my salinity 1.26 I switch salt mixes with the old mix the mg was always good so I never really worried about the mg I rarely checked it since I started this tread I started to check it again and yes its low so I'm going to start dosing it and also make sure my change water parameters are right will keep posted thks everyone for your help
|
|
|