|
12/16/2017, 07:02 PM | #1 |
Registered Member
Join Date: May 2011
Posts: 408
|
Water sensors and feed mode
So I have an extension that connects some equipment in my sump. There is a water optical sensor in the sump that turns offs everything in case there is a water level raise. I dont want it to work like that when the feed mode is on. Is there a way to do it?
So far the code is: Fallback ON Set OFF If Time 08:58 to 22:15 Then ON If Sensum CLOSED Then OFF If Sensfl CLOSED Then OFF If FeedA 000 Then ON It works like its desired but when the feed cycle A is over it will turn everything off, which is something I dont want. Any help is appreciated. Thanks in advance. |
12/16/2017, 08:45 PM | #2 |
Registered Member
Join Date: Jun 2010
Location: Tampa
Posts: 643
|
I'm a little confused as to what you want to do. Are you wanting certain equipment to turn off or stay on when feed mode is activated? And do you want it to ignore switch state when feed mode is activated?
__________________
Matt Don't pee on my leg and tell me it's raining. Current Tank Info: 190 |
12/18/2017, 12:38 PM | #3 |
Registered Member
Join Date: May 2011
Posts: 408
|
To stay on when the feed mode is activated.
Sent from my SM-G950F using Tapatalk |
12/18/2017, 04:15 PM | #4 |
Registered Member
Join Date: May 2011
Posts: 408
|
Done. I had to put a delay in the feed timer.
Thanks! Sent from my SM-G950F using Tapatalk |
01/02/2018, 08:48 PM | #5 |
Registered Member
Join Date: Oct 2015
Posts: 312
|
I’d be interested in seeing your solution- I’m anticipating this situation once I set mine up in a few weeks
Thanks |
01/02/2018, 08:59 PM | #6 |
Registered Member
Join Date: May 2011
Posts: 408
|
The code would be this
Fallback ON Set OFF If Time 08:58 to 22:15 Then ON If Sensum CLOSED Then OFF If Sensfl CLOSED Then OFF If FeedA 015 Then ON Sent from my SM-G950F using Tapatalk |
|
|