|
07/31/2007, 06:56 PM | #1 |
Registered Member
Join Date: Mar 2004
Location: Las Vegas
Posts: 476
|
Anyway to see breakout sensor status?
I just hooked up my breakoutbox and a water on the floor sensor. I set an alarm as well as some other settings:
If SwitchA1 CLOSED Then PM1 OFF If SwitchA1 CLOSED Then WV1 OFF If SwitchA1 CLOSED Then WV2 OFF If SwitchA1 CLOSED Then ALM ON WV is of my koralias that point at the glass, I want to lower the flow on the glass if it is overflowing. Ok so Im testing and everything is working great, but the alarm email doesnt tell me whats at fault.So as the title says how can I see the status of the sensor on my alerts? |
08/01/2007, 03:24 PM | #2 |
RC Sponsor
Join Date: Aug 2001
Location: San Jose, CA
Posts: 4,311
|
Just add a timer name that points to a bogus control address, and make the state of that timer reflect the state of the switch. Like:
SW1$-P1 If SwitchA1 OPEN Then SW1 OFF If SwitchA1 CLOSED Then SW1 ON Curt |
12/30/2012, 04:38 PM | #3 |
Registered Member
Join Date: Feb 2009
Location: edmonton alberta canada
Posts: 20
|
I love you guys as i have faught with it for years ! it worked 100%
|
12/30/2012, 09:31 PM | #4 |
Registered Member
Join Date: Dec 2011
Location: Las Vegas, NV
Posts: 430
|
Extremely old post.
New firmware allows for direct viewing, but can't currently label them directly. Sent from my phone. Excuse abbreviated responses. |
Thread Tools | |
|
|